Safety valve operating matters
2015-12-11 by bridge
1. To keep clean safety valve to prevent the valve spring stalks, etc. are full of dirt or corrosion grease to prevent the gas valve discharge pipe is clogged oil or other foreign matter; always check seal is intact, preventing the lever-type safety valve hammer loose or moved, preventing the spring-loaded safety valve adjustment screw is free to twist.
2. After cleaning the safety valve must be re-commissioning.
3, should be used to clean light oil valve.
4, after the beginning of the operational phase of commissioning, should be carefully observed the operation of the safety valve.
5, found a Pilot Safety Valves when there is evidence of leakage, it should be replaced or serviced. Prohibit the use of increased load (eg adjusting screw on the lever or safety valve lever and hang heavy loads over tighten the spring-loaded safety valve) is the way to eliminate leakage.
6, regularly check the operation of the safety valve leaks, appropriate measures to jamming and spring corrosion and other irregularities, and to observe the adjustment nut and adjusting ring set screw lock nut is loose, if a problem should take timely .
7, the valve is installed outdoors should take appropriate protective measures to prevent the rain and fog, dust, rust and other dirt pollution and invasive valve discharge pipe, when the environment is below zero degrees Celsius, freezing should take the necessary measures to ensure safety valve reliability.
8, except to comply with the rules outside of the gas valve when operating